Professional Sound Corporation M 8 Spécifications

M 8 MIXER MANUAL Operation Manual V1.0 Copyright 1998 Professional Sound Corporation

of the five active gain positions on this switch that provides you with a comfortable listening level and leave the switch set to this position under

Page 7 3.05 HEADPHONE OUTPUTS-DIRECTOR The M8 Mixer is also equipped with an additional headphone feed labeled as "Director". Th

audible tone used to easily identify slates during editing. This feature can be turned off internally if desired. Page 8 3.08 PRIVATE LINE: T

jack is used when the boom operator wishes to use an external talk back microphone. This jack provides positive bias to external electret microphones

bulbs. (A high intensity LITTLITEtm is included with the M8 Mixer) please note that the high intensity LITTLITEtm draws approximately 5 watts, nearly

recharged from an appropriate external charger connected to the external power input XLR connector. Pin outs are as follows: Pin 1 ground (-), Pin 3

still popular in the USA. The V.U. (volume unit) meter is average reading and was designed to approximate the equivalent loudness as perceived by th

The M8's internal speakers are very small 40 mm (1.57") and offer limited bandwidth. This is a trade-off between performance and size and w

The side panels of the M8 Mixer are decorative in nature. They are screwed onto the actual, welded structural sides of the housing. These side pane

Page 15 9.01 CONNECTOR PIN OUTS: The following information is provided for use of technicians and other qualified individuals desiring to buil

Printed in the U.S.A. Introduction Professional Sound Corporation is a leading manufacture and distributor of professional audio products for the

TT-2: Same As Above Speaker TT: Tip = Speaker (+) Ring = Speaker(-) Sleeve = No Connection Page 16 SPECIFICATIONS: Chassis Size

Mic Power: 12T, 48PH, Dyn to DIN Specs Meters: LCD Bargraph, Peak Reading, 40dB range Page 17 Monitor Speakers: Stereo, 40mm, 1 watt per c

Copyright 1998 Professional Sound Corporation, all rights reserved, no portion of this manual may be reproduced or used for commercial purposes withou

5.01 LCD METERS PAGE 13 6. MONITOR SPEAKERS: 6.01 POWER AMPLIFIERS PAGE 13 6.02 INTERNAL SPEAKERS PAGE 13 6.03 EXTERNAL SPEAK

INPUT SECTION: 2.01 TRANSFORMER INPUTS The M8 mixer uses a transformer coupled input preamp design topology. Transformer coupled inputs were

microphones can easily power them from the M8 Mixer using a phase inverting barrel (PSC part # FPSC0010C) or a phase reversing cable (PSC part # FPSC1

Page 3 2.05 PREAMP GAIN: The preamplifier circuits of the M8 are split in two distinct gain stages separated by a "gain" control.

frequency of 10Khz and allows a cut or boost of 10dB. The mid frequencies center frequency is adjustable from 2Khz to 5Khz. It offers a cut and boos

audio from that individual input channel is routed directly to the "mixer" headphones. The normal headphone source is momentarily interrupt